Napoleon Galaxy 74" Outdoor Gas Fireplace
70,000 BTU/hr on natural gas, or on propane with Napoleon's conversion kit, from a 304 stainless steel firebox with a 74-1/16" by 20" viewing area. The Napoleon Galaxy 74" is a built-in outdoor gas fireplace for a patio or yard. It frames into an enclosure 79" wide, 40-1/2" high and 17" deep, ships with a clear glass ember bed, a glass wind guard and multi-colour LED lighting, and lights by electronic ignition from the wall switch that comes with it. It is priced from $6,189, with Napoleon's 5 Year Limited Warranty.
Choose the Galaxy 74" if you want a long, low ribbon of fire built into an outdoor wall, kitchen or pillar, with lighting you can change from night to night, and a look you can change later with Woodland media, glass beads, glass embers or a high definition birch, oak or driftwood log set.
It is not right for indoor use or for a fully closed room — it is an outdoor appliance, and any shelter it sits in must stay at least 30 percent open. It is also not a heater: Napoleon certifies it as a decorative outdoor appliance. And it is not freestanding — it has to be built into a framed enclosure at least 72" tall with a non-combustible finish around the opening and a hard-wired 120 V supply, and it is not waterproof, so it should not go where water runs or pools.
Specifications
The framed opening is 79" wide, 40-1/2" high and 17" deep; the fireplace itself is 78-9/16" wide, 40-1/8" high to the top of its standoffs and 15-15/16" deep. The enclosure must be at least 72" tall from the bottom of the fireplace, with the ceiling no lower than that. Combustible framing may touch the standoffs at the sides, finishing material keeps 1" from the back and 1/4" from the sides, and any finish over the face within 14" above the opening and 3-1/4" beside it must be non-combustible. Mantel clearance depends on the mantel's depth and on whether the screen kit is fitted — see the table on page 22 of the installation manual. Keep furniture at least 4 feet from the front.
The Galaxy 74" vs. the see-through model and the other widths
The Galaxy 74" See-Through is this fireplace built with the see-through conversion kit, so the fire shows from both sides and the framed depth drops to 15-15/16". It is priced from $7,128; this single-sided model is from $6,189. The Galaxy 50" and 62" are rated 50,000 and 60,000 BTU/hr and priced from $4,619 and from $5,139.
Features
- 70,000 BTU/hr on natural gas, or on propane with Napoleon's conversion kit
- 304 stainless steel firebox with a 74-1/16" by 20" viewing area behind a glass wind guard
- Multi-colour LED lighting in the ember bed and wind guard, on its own switch on the included wall control
- Clear glass ember bed included; Woodland media, glass beads, glass embers and high definition log sets can be added
- Electronic ignition, plus a micro switch that keeps the fire off while the weather cover is on
- Finishing flange included, for a clean full-view opening in a stone, brick or tile surround
Answers to common questions
What’s included, what’s required, and what’s optional?
-
Included in the box: Clear Glass Ember Bed; Stainless Steel Interior; Tempered glass wind guard; Multi-colour LED ember bed and wind guard lighting; Electronic ignition with a wall mount control switch and 20' of wire; Stainless steel gas flex connector with manual shut-off valve; Finishing flange and nailing tabs; Napoleon 5 Year Limited Warranty.
-
Required to complete the installation, purchased separately: Enclosure - a framed outdoor enclosure at least 72" tall, finished in non-combustible material around the opening; see pages 16 and 20 of the installation manual for the framing dimensions; Gas Line - a 1/2" natural gas line to the included flex connector, or a propane cylinder or propane line once the fireplace is converted, run by a qualified installer; Electrical - a 120 V supply hard-wired to the fireplace.
-
Optional: MIRRO-FLAME porcelain reflective radiant panels - an interior panel upgrade, choose above; High Definition Birch, Driftwood or Oak log sets, sold separately below the cart; The Prestige Heat and Exhaust Management Kit, High Definition Birch, Driftwood or Oak log sets, the outdoor timer kit, the premium screen kit and the brushed stainless weather cover — the fireplace operates fully without any of them.
Where can the Galaxy be installed?
Outdoors only — on a patio or in a yard, never indoors or inside the warm-air envelope of a house. A sheltered spot is best, because direct wind makes the flame erratic. It can sit under an overhead cover with no more than two side walls, or under a cover with three walls as long as at least 30 percent of the perimeter stays permanently open — a covered patio, a gazebo or an outside wall of the house all work. Keep furniture at least 4 feet from the front.
Can the Galaxy run on propane as well as natural gas?
Yes. It ships for natural gas; choose Propane above and Napoleon's conversion kit (W175-10003381) is added to your order, and a qualified service technician fits its regulator and orifices. On propane it runs from a 20 lb or 30 lb cylinder (not included), which always stays outside any structure the fireplace is in, or from a hard-piped propane line. It is rated 70,000 BTU/hr on either gas, up to 4,500 ft.
Does the Galaxy need a chimney or vent pipe?
No vent is required. If you want more freedom in how the enclosure is built, Napoleon's optional Prestige Heat and Exhaust Management Kit carries heat and exhaust out of the enclosure through 6" B-vent, rising at least 36" — it has to be fitted during installation, so decide on it before the enclosure is built.
How do I protect the Galaxy from rain and weather?
The firebox is 304 stainless steel and drains water through holes along its sloped front, but the fireplace is not waterproof: the enclosure must be finished with every joint sealed, and it should not go where water runs or pools. Between uses, cover the opening — the optional brushed stainless weather cover hangs over the front, and a micro switch keeps the fire off while it is on.
Can I put a mantel above the Galaxy?
Yes. How high a combustible mantel has to sit depends on how deep it is, and on whether the screen kit is fitted — see the table on page 22 of the installation manual. Napoleon recommends a non-combustible mantel. You can also send us your mantel depth. We're here to help!
Does buying from The Torch Guys affect my Napoleon warranty?
No. The Torch Guys is an authorized Napoleon dealer, so Napoleon's 5 Year Limited Warranty applies in full, and we file claims with Napoleon for you. The stainless steel components are covered for five years; electrical parts, wearable parts such as the gas valve and logs, and the labour are covered for the first year. Coverage starts on the installation date, for a fireplace installed in the United States or Canada.
Pro Portal
Dedicated Support
Best Price
Large Selection
Exclusive Deals
Priority Shipping
