Majestic Jade 42" Linear Direct Vent Gas Fireplace
What's Included?
Here's what ships in the box and what you'll choose above before checkout. Not sure what you need? Call us at (410) 324-6322 and our team will spec the right setup.
Here's what ships in the box and what you'll choose above before checkout. Not sure what you need? Call us at (410) 324-6322 and our team will spec the right setup.
The Majestic Jade 42" is a linear direct vent gas fireplace with IntelliFire Touch electronic ignition and battery backup: up to 25,250 BTU/hr on natural gas or 23,500 on propane, bronze glass media standard, a 49" wide, 32-3/4" high and 17-3/4" deep framed opening and a 4" x 6-5/8" top vent, from $3,459. A decorative front finishes it, with Clean Face trim in three finishes or a black Picture Frame front.
Choose the Jade 42" if you want a linear fire you can restyle: bronze glass is standard, diamond, onyx or sapphire crushed glass or natural stones can replace it, and a Driftwood log set, reflective black glass interior panels and LED accent lights are available. With only 1/2" of clearance at the back and sides and no raised hearth, it frames tightly into a wall, and it is certified for bedrooms.
It is not right for you if you are looking for a traditional arched fireplace. The Jade 42" is a straight linear fireplace, with a bed of bronze glass media standard.
The framed opening is 49" wide, 32-3/4" high and 17-3/4" deep, and the fireplace itself is 48" wide, 33-11/16" high and 17-3/4" deep. Keep 1/2" of clearance at the back and sides and 31" from the top of the opening to the ceiling, and no raised hearth is needed. The non-combustible board ships with the fireplace, and the wall around it can be finished with 1/2" drywall. Mantel clearance depends on the mantel's depth and is charted in Figure 10.3 on page 62 of the installation manual, with a separate chart in Figure 10.4 for the Passive Heat Kit. It takes a 1/2" gas line and an unswitched 110-120 VAC circuit.
The two Jade sizes share the bronze glass media, IntelliFire Touch ignition, fronts in the same four styles and the 4" x 6-5/8" top vent. The 42" runs 25,250 BTU/hr on natural gas and frames 49" wide, from $3,459, and has its own propane model. The 32" runs 19,000 BTU/hr and frames 37" wide, from $2,809, and propane is added with a conversion kit.
It vents off the top only, on 4" x 6-5/8" SLP direct vent pipe, out through a wall or up through the roof: up to 60 ft straight up, up to 14 ft horizontal, and 40 ft of combined run where elbows are used. It needs 12" of vertical pipe off the top before an elbow, and its three horizontal elbow layout is for natural gas only. SLP-FLEX flexible pipe cuts the total horizontal by 25%, except in a simple up and out layout. It can also vent up an existing chimney with the DV-46DVA-GCL adapter and LINK-DV30B liner kit, and it is approved for the PVLP-SLP, PVI-SLP-B and PVV-SLP power vents with the wire harness and IFT-RC400 remote. Our team builds the vent package for your run; the approved parts are on page 71 of the installation manual and the termination clearances on pages 22 to 25.
The bronze glass ships with the fireplace. To change it, the 42" takes 3 bags of glass or 6 bags of natural stones, and choosing one above adds the right number of bags. If you add the Driftwood log set with stones, it takes 1 bag of stones. Glass goes in an even layer around the base pan, never on the burner.
A remote is optional. The control module has a switch for on, off or remote. Set to on, it runs continuously at high flame. Set to remote, it answers a wired wall switch, the IFT-RC150 wireless wall switch or the IFT-RC400 remote, and flame height is adjusted from the remote. A fan or LED lights also need the IFT-RC400, and so does the Heat-Zone kit. Battery backup keeps it lighting in a power outage, though a fan and lights do not run on battery.
Yes, with planning. Without a passive heat kit, Majestic's good faith guideline is a mantel 18" above the opening, with the TV 2" to 3" above the mantel and the mantel standing 2-1/2" past the TV (Figure 2.3 on page 8 of the installation manual). The optional Passive Heat Kit moves heat out through a discharge opening, and then no mantel is needed: 12" from the opening to the bottom of the TV, a 2" air gap behind it and 4" from the top of the TV to the discharge opening (Figure 2.4 on page 9). The kit goes in with the fireplace, while its top is accessible. Always stay within your TV maker's own temperature limits.
Inside a framed wall, with 1/2" of clearance at the back and sides, 31" from the top of the opening to the ceiling and 36" clear in front. It can sit on a combustible floor with no raised hearth, or be raised off the floor on a platform. It is certified for bedrooms and bedsitting rooms, and may be installed as an OEM installation in a manufactured or mobile home. Adhesive vinyl flooring is not recommended. Rated input is for 0 to 2,000 ft and is reduced 4% per 1,000 ft above that in the USA.
On natural gas or propane it takes a 1/2" gas line to the shut-off valve and flex connector that come with it, plus an unswitched 110-120 VAC circuit wired with 14-2 AWG with ground to the junction box. Inlet pressure is 5" to 10" w.c. on natural gas and 11" to 13" w.c. on propane. Natural gas and propane are separate models, so choose your fuel above.
No. The Torch Guys is an authorized Majestic dealer, and the warranty covers fireplaces bought from one. On a gas fireplace the firebox and heat exchanger carry 20 years on parts and 3 on labor, burners and metal or fiber refractory 10 years on parts and 1 on labor, electrical components and glass liner panels 2 years, and all other parts 1 year. We will help you with any claim.