Skip to content
FREE Shipping On Orders Over $399!

Ask An Expert

(410) 324-6322

Ask An Expert

(410) 324-6322

(410) 324-6322

Live Chat

Email Us

Hours:

Mon-Sat - 8am-10pm EST

Sunday - Closed

Hours: Mon-Sat - 8am-10pm EST
by Majestic Authorized Dealer

Majestic Lanai 48" Outdoor Linear Vent Free Gas Fireplace

SKU ODLANAIG-48
What's Included?

Here's what ships in the box and what you'll choose above before checkout. Not sure what you need? Call us at (410) 324-6322 and our team will spec the right setup.

✓ Included Standard
Crystal Crushed Glass
Deflection glass
IntelliFire electronic ignition
Wall control for the flame and the lights
Multi-colored LED light strips
T-handle shut-off valve and flexible gas connector
8" cement board for the wall above the fireplace
Limited Lifetime warranty on the body and firebox
🔧 Options
Above the Cart (select from dropdown)
Fuel Type: Natural Gas or Propane
Burning Display: Crystal crushed glass included standard; upgrade to 4 colors of crushed glass or a stone kit, or No Thanks (no media upgrade)
Log Set: Driftwood Logs or No Thanks
Below the Cart (select from optional accessories section)
Framed Screen Barrier, Clean Face Trim Kit, Drain Pan
⚠️ Required to Complete Installation
Enclosure - stand-alone framing or a built-in wall, finished in non-combustible material with every joint sealed.
Gas Line - a 1/2" natural gas line to the included shut-off valve, or a propane supply once the fireplace is converted, run by a qualified installer.
Electrical - an unswitched 110-120 VAC circuit with GFCI protection.
Original price $4,639.00 - Original price $5,793.00
Original price
$4,639.00
$4,639.00 - $5,793.00
Current price $4,639.00

Optional Accessories

About This Product

Majestic Lanai 48" Outdoor Linear Vent Free Gas Fireplace

55,000 BTU/hr across a 47-7/8" by 17" viewing area. The Majestic Lanai 48" is a single-sided outdoor linear gas fireplace in rust-resistant stainless steel, with crystal crushed glass, multi-colored LED lighting, IntelliFire ignition and a wall control included. It needs no chimney or vent pipe and frames into an opening 52-3/4" wide, 39-3/4" high and 13-3/8" deep. It runs on natural gas, or on propane with the LP conversion kit. It is priced from $4,639, with a Limited Lifetime warranty on the body, firebox and heat exchanger.

Choose the Lanai 48" if you want a long ribbon of flame on a patio, terrace or outdoor wall without running a vent. Change the look with amber, scarlet, ebony or cobalt crushed glass, a stone kit, or driftwood logs, and the LED colors change it again after dark.

It is not right for you if you are looking for a tall, traditional firebox opening. The Lanai 48" spreads its flame across a 47-7/8" wide, 17" tall view, so the fire reads as one long line along the wall.

Specifications

The framed opening is 52-3/4" wide, 39-3/4" high and 13-3/8" deep; the fireplace itself is 52-1/8" wide, 39-1/2" high and 13-3/8" deep and weighs 215 lb. It sits at least 39 in. below a soffit, veranda or overhang, 60 in. below a vinyl soffit and 72 in. below a vinyl or composite overhang. Framing and clearance details are in Figure 3.3 on page 10 of the installation manual, and mantel clearances are charted in Figure 7.1 on page 23. It needs an unswitched 110-120 VAC circuit with GFCI protection.

The Lanai 48" vs. the 60", the 72" and the See-Through

The Lanai 60" and 72" keep the same 17" view height across 60" and 72" widths at 65,000 BTU/hr, for longer walls. This 48" is from $4,639 and rated 55,000 BTU/hr. The Lanai 48" See-Through shows the fire from both sides, for a spot between two outdoor spaces.

Features

  • 55,000 BTU/hr on natural gas, or on propane with the LP conversion kit
  • A long, low 47-7/8" by 17" viewing area with crystal crushed glass and deflection glass included
  • Multi-colored LED lighting with seven solid colors and two color fades, on its own buttons, with the flame on or off
  • IntelliFire electronic ignition, with an included wall control that mounts up to 14 ft away
  • Rust-resistant stainless steel, with drain holes in the base for rain
  • Stands alone in its own framing or builds into a wall, with no chimney or vent pipe

Answers to common questions

What’s included, what’s required, and what’s optional?
  • Included in the box: Crystal Crushed Glass; Deflection glass; IntelliFire electronic ignition; Wall control for the flame and the lights; Multi-colored LED light strips; T-handle shut-off valve and flexible gas connector; 8" cement board for the wall above the fireplace; Limited Lifetime warranty on the body and firebox.
  • Required to complete the installation, purchased separately: Enclosure - stand-alone framing or a built-in wall, finished in non-combustible material with every joint sealed; see Figure 3.3 on page 10 of the installation manual; Gas Line - a 1/2" natural gas line to the included shut-off valve, or a propane supply once the fireplace is converted, run by a qualified installer; Electrical - an unswitched 110-120 VAC circuit with GFCI protection.
  • Optional: The driftwood log set, sold as a choice above; the fireplace runs fully without a log set; The framed screen, clean face trim kit and drain pan, sold below; the fireplace operates fully without them.
Where can the Lanai 48" be installed?

Outdoors only. It can stand in walls with no roof, under a roof with no more than two side walls, or under a roof with three side walls as long as at least 30 percent of the perimeter stays permanently open. It can stand alone in its own framing or be built into a wall, on a continuous flat surface of wood, composite or non-combustible material, with no separate floor protection.

Does it need a chimney or vent pipe?

No. The Lanai 48" is an outdoor appliance with no vent run: it connects to gas and power only. What it does need is open air around it, which is why the shelter limits above apply, and at least 39 in. below a soffit or overhang.

Can it run on propane?

Yes. It ships for natural gas. Choose Propane above and the LP conversion kit (LPK-ODLANAIG48) is added to your order, and a qualified service technician fits it. It is rated 55,000 BTU/hr on either gas. In the U.S. the input is reduced 4% for each 1,000 ft above 2,000 ft.

Can I mix crushed glass, stones and logs?

Crystal crushed glass ships with the fireplace. You can add a colored glass kit, the driftwood log set, or the stone kit, which is set over the crushed glass. The stone kit and the log set are the one pairing that cannot be used together, so the page does not offer it.

How does it handle rain?

The Lanai is built to run outdoors in rain, and drain holes in the base let water through. It sheds moderate water but is not waterproof, so the enclosure has to be sealed at every joint and give that water a way out at its lowest point. The optional drain pan channels moisture to the front or rear of the enclosure. The optional screen keeps out leaves and debris, and the fireplace may run with it in place. Glass doors must not be installed on it.

Can I put a mantel above it?

Yes. How high it has to sit depends on the mantel's depth and on whether it is combustible, and it is charted in Figure 7.1 on page 23 of the installation manual. You can also send us your mantel depth. We're here to help!

Does buying from The Torch Guys affect my Majestic warranty?

No. The Torch Guys is an authorized Majestic dealer, and the warranty covers products bought from one. The body, metal firebox and heat exchanger carry the Limited Lifetime warranty; gas and electrical parts, glass, optional accessories and labor are covered for one year. Installation by a qualified installer applies, and we will help you with any claim.

  • Model ODLANAIG-48
  • Brand Majestic
  • Fuel Type Natural Gas or Propane (choose above)
  • Venting Type None; no chimney or vent pipe
  • Ignition Type IntelliFire electronic ignition, wall control
  • BTU (Natural Gas) 55,000 BTU/hr
  • BTU (Propane) 55,000 BTU/hr (after conversion)
  • Viewing Area 47-7/8" W x 17" H
  • Unit Width 52-1/8"
  • Unit Height 39-1/2"
  • Unit Depth 13-3/8"
  • Framing Width 52-3/4"
  • Framing Height 39-3/4"
  • Framing Depth 13-3/8"
  • Electrical 110-120 VAC, 60 Hz, under 12 A, GFCI circuit

Shipping & Returns

Free curbside freight delivery on every order over $399. Inspect the shipment before signing and note any damage on the delivery receipt — freight damage claims must be reported within 5 business days. Most items can be returned within 30 days of delivery as long as the product hasn't been installed, is in the same condition you received it, and all original packaging is intact. Return shipping and the original outbound freight cost are deducted from the refund, and a manufacturer restocking fee may apply. Custom and made-to-order products are final sale. Cancellations are free any time before shipment (custom orders excepted). Threshold and white-glove delivery upgrades are available — ask our team.

Full shipping policy · Full return policy · Questions? Call (410) 324-6322 — when you call, we answer.

Warranty

In the unlikely event your product experiences a defect, our technical team will guide you through the manufacturer’s warranty process. Here is a general outline of what to expect.

Due to the technical nature of our products, the manufacturer must perform troubleshooting to process a warranty claim. Your installer will need to troubleshoot the problem on-site while working in tandem with our technical team. If troubleshooting leads to what The Torch Guys deems as a defective part, we will submit a warranty claim to the manufacturer on your behalf. Before we submit the claim, we will ask you to review the terms and confirm your consent to proceed.

Once the claim is submitted, the manufacturer will review it and either approve or deny it. If they have all the information and accept the claim, your warranty replacement part(s) will begin processing for shipment. If, for any reason, the claim is denied or we need more information, we will notify you as soon as possible.

All warranties are processed as exchanges. You can expect to receive a prepaid return label for the defective part(s), which must be returned within 30 days of receiving the warranty replacement(s).

Warranty claims can take anywhere from 1-4 weeks to process, depending on the season. Given the length of time claims can take, we recommend you fire up your unit in late summer/early fall to ensure your existing fireplace is in good working order for the winter season.