
Superior DRT2033 33" Traditional Direct Vent Gas Fireplace
What's Included?
Here's what ships in the box and what you'll choose above before checkout. Not sure what you need? Call us at (410) 324-6322 and our team will spec the right setup.

Here's what ships in the box and what you'll choose above before checkout. Not sure what you need? Call us at (410) 324-6322 and our team will spec the right setup.
A 33" traditional direct-vent gas fireplace that frames into just 14-1/2" of depth. The Superior DRT2033 is sealed combustion — it takes its air from outside and vents directly to the outside — and comes as a dedicated top-flue or dedicated rear-flue model, so pick the one that matches your vent route. The clean-faced, louverless firebox burns through a five-piece log set over volcanic stone and glowing embers, runs 12,000 BTU/hr on natural gas at 64.8% P4 efficiency — with a dedicated propane model at 10,000 BTU/hr — and lights on an electronic intermittent pilot with four AA batteries backing up fireplace operation through an outage. from $2,169.
Choose the DRT2033 if you want a traditional log fire in a shallow wall — the 14-1/2" framing depth and 34-1/8" opening fit where deeper fireboxes will not — and you know which way your vent will run and which gas you have, because both the flue direction and the fuel are built into the model you order.
It is not right if there is no route to an outside wall or roof, or if you need primary heat for the room. This is a sealed direct-vent firebox that must vent directly to the outside, and Superior designs it as a supplemental heater, with an alternate primary heat source advised. For an interior room with no venting path, a vent-free or an electric model is the one to look at instead — and if you would rather have a contemporary crushed-glass firebox than logs, the Superior DRC2033 is this same 33" dedicated-flue construction in the contemporary trim.
Frame a minimum opening 34-1/8" wide and 14-1/2" deep, allowing 36-7/8" of height for a top-vent installation or 19-5/8" for a rear-vent one. Combustible mantel clearance depends on how deep the mantel is, and combustible side walls follow the manual's side-clearance figure — see Figures 6 and 7 on page 15 of the installation manual; the ceiling must be at least 64" above the bottom of the unit. It vents on 4-1/2"/7-1/2" Secure Vent rigid, Secure Flex or Z-Flex Model GA components, with compact horizontal termination kits offered, and vent runs chart to 25 ft horizontal and 60 ft vertical. Tested and listed by PFS TECO to ANSI Z21.88-2019, report F13-094.
The Top Vent and Rear Vent choices are two dedicated-flue constructions — the flue is on top of the firebox on the Top Vent model and on the back of the Rear Vent model — and the direction is built in, not field-convertible. Rear vent gives the lowest possible shelf height above the fireplace (34" versus 44"-46" top-vented) and the shortest framing height (19-5/8" versus 36-7/8"); top vent suits vertical runs. Pick by your vent route, and send us the wall build-up if you want us to check it.
Yes. The electronic ignition uses external power, but four AA batteries in the battery holder provide backup power and keep the fireplace operating through an outage. The optional blower is the exception — it needs mains power and will not run without it.
Yes — propane is a factory-built model here, not a conversion. Choosing Propane on this page orders the dedicated propane unit (top or rear vent), which runs 10,000 BTU/hr and sells at the same price as the natural gas model. The appliance is only for use with the gas on its rating plate and is not convertible to the other fuel unless a certified kit is installed.
Combustible mantel clearance depends on how deep the mantel is, and combustible side walls follow the manual's side-clearance figure — see Figure 7 and Figure 6 on page 15 of the installation manual. For a utility shelf above the fireplace (the manual notes shelves like these are commonly used for locating television sets), the minimum height from the base of the fireplace to the underside of a combustible shelf is 44" top-vented with a rigid elbow, 46" with a flex elbow, or 34" rear-vented — and the space between the fireplace and the area above it must not be insulated.
Yes — it is listed for installation in bedrooms and manufactured homes, and may be installed in an aftermarket, permanently located, manufactured home (USA only) or mobile home where not prohibited by local codes. In a manufactured home the appliance must be grounded to the chassis per local codes or the National Electrical Code.
Superior warrants the fireplace, and The Torch Guys handles it for you — we register the appliance and, if you ever need to claim, we deal with the manufacturer on your behalf rather than handing you a phone number. Keep your invoice and the model number; we hold the rest on file.